🎉Independence Day Promotion!!! 🎉
- 😍BUY 2 Complete Sets FREE SHIPPING!!!
- 🔥WE HAVE VERY LIMITED QUANTITIES AT THIS PRICE!!🔥
- Suitable for any car model
- Easy to install without disassembly the headlights
- Non-flammable fire retardant burn
- Silicone material with good seal, waterproof , energy saving, anti-corrosion.
- Daytime running light strips are different from high beam, NO GLARE.
- Only 4mm thick, can be installed in the gap between the Headlights and the Engine Hood with adhesive tape, no drilling, no screwing and no disassembling needed.
- Lights are white when turn signal light is off, then the lights flow yellow when turn signal light is switched on.
- Handpicked SMD-3014 LEDs, no dead light and dark spots, brighter than the stock halogen headlight bulbs. It's a good replacement light for car original headlight.
- Unlike old designs where the DRL and Turn Signal share the IC Controller, these lights have separate IC Controllers which guarantee stability.
- Faster on/off response time and vibration resistant
- Power off during your customizing installation
- Cut down the strip along the line.
- Make sure no debris gets in.
- Sealing the tube with insulated glue after cutting in short.
Easy Installation, just require right connect to positive and negative side
- Red wire: Power Positive(+)
- Black wire: Power Negative(-)/Ground
- Yellow wire: Left or Right Turn Signal Positive(+)
- Step 01:Turn on the original headlights(5 screws in total).
- Step 02:Remove the headlights and clean the sand dust.
- Step 03:The buckle(near the middle net) first aims at the LED eyebrow then install.
- Step 04:LED eyebrow threading
- Step 05:aim at the buckle and install the LED eyebrow
- Step 06:Tighten 5 screws.
- Step 07:Connect with the LED eyebrow with the controller socket.
- Step 08:Pull out the turn light.
- Step 09:Connect the yellow wire to the positive pole of the turn light(Do not touch the negative pole).
- Step 10:Connect the red wire to the ACC.
- Step 11:Connect Black wire to the iron or the screw.
- Step 12:Finished install the LED eyebrow, then test the effecting.
Universal fit for all 12V/24V auto vehicle, commonly used for Car, SUV, Vans, Truck, RV, Motorcycle, Scooter, Trailer etc.
- Material: Soft Rubber Tube.
- Input Voltage: 12V/24V
- Power Rating: 5.5W
- Lifespan: 50,000 hours
- Working Temperature: -40-60 ℃
- Length: 45cm(17.72in),46cm(18.11in),60cm(23.62in).
- 1 x LED Strip
- 1 x Adapter Wire
- 1 x Instruction Manual
- Please test the lights to ensure they are working before proceeding with any type of work.
- Don't stress the cables or bent too much when you try to open the headlight to install them.